Aroma OTS

Piping Engineeering

Key aspects :

•Preparation of Design basis and Specifications
•Development of the plot plan, Equipment Layout and Piping studies and Isometric drawings.
•Preparation of material take off’s / requisition for piping and specialty items
•Preparation of stress critical line list and Stress analysis (CAESAR II)
•Pipe support engineering including special supports preparation
•Review and approval of vendor drawings

Electrical Engineeering

Key aspects :

•Load flow studies
•SLD, cable selection and Selection of HV/LV switchgear, motor control centers
•Selection of AC/DC UPS, power / distribution transformers
•Harmonic Analysis
•Switchyard / transformer layouts, Cable tray / trench layouts
•Lighting (indoor/outdoor) layouts
•Power and control cable schedules and cable drum schedules
•cable trays, earthing & Lightning protection studies etc.
•Review of vendor drawings and issue of approvals for manufacturing

Civil & Structural Engineeering

Key aspects :

•Reviewof Topo study and Geotechnical studies for design basis of civil structures.
•Preparation of design calculations
•Preparation of bar bending schedules
•Reinforced concrete framed structures
•Pile and conventional foundations
•Equipment and machinery foundations
•Steel framed buildings and superstructures
•Pipe and cable rack structures, conveyor galleries, trestles, stack supporting structures and platforms
•Turbine houses, workshop buildings, etc.

Mechanical Engineeering

Key aspects :

Instrumentation & CS Engineeering

Key aspects :

•Preparation of instrument index
•Preparation of interlock logic diagrams
•Preparation of cable tray / cable trench layouts
•Preparation of junction box termination drawings
•Preparation of instrument hook up drawings
•Preparation of cable schedules
•Preparation of requisition and specifications for instruments
•Sizing of control valves ,orifice plates and relief valves
•Preparation of interface drawings for DCS, PLC,SCADA & MCC
•Attending SAFOP / HAZOP meetings

Process Engineering

Key aspects :

•ProcessFlow Diagrams.
•Heat and mass balances.
•Optimisation of process requirements.
•Surge analysis and steady flow analysis. .
•Creation of intelligent P&IDs in Smart Plant P&ID including customization of legend, reports, and borders
•Sizing and Hydraulic calculations
•Performing insulation and heat tracing calculations
•Preparation of line list, equipment list, valve list, etc